Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
cont.
Ifyou experience
Possible Causes
Cycle time too short
Automatic
cycle ending
early.
Lint on load
Stains on load or drum
Lint screen clogged.
Dryer fabric
softener
not properly
used.
Solution
The load may
not be contacting the sensor strips. L evel the dryer.
Use Time Dry for very small loads. Change
the Dry Level
setting
on Auto
Dry Cycles.
increasing
or decreasing
the Dry Level setting
will change
the
amount
of drying
time in a cycle,
if loads are consistently
ending
too early,
see "Changing
the EvenHeat
TM
Auto Dry Cycle Settings
to increase
Drying
Time".
Lint screen should
be cleaned
before
each load.
Add dryer
fabric
softener
sheets at the beginning
of the cycle.
Fabric
softener
sheets added
to a partially
dried
load can stain
your garments.
Drum stains are caused
by dyes in clothing
(usually
blue jeans).
These wJJJnot transfer
to other clothing.
Loads are wrinkled
Was the load
not removed
from
Select Wrinkle
Guard
TM
feature
to tumble
the load without
heat
dryer at the end of the cycle?
to avoid
wrinkling.
Dryer overloaded.
Dry smaller
loads that can tumble
freely
reduce
wrinkles
from
forming.
Odors
Have you recently
been painting,
If so, ventilate
the area. When
the odors or fumes are gone from
i staining,
or varnishing
in the area
the area, rewash
and dry the clothing.
i where your dryer
is located?
Is the electric
dryer
being used for
The new electric
heating
element
may
have an odor. The odor
i the first time?
wJJJbe gone
after the first cycle.
Load is too hot
i Were laundry
items removed
from
Allow
Cool Down to finish before
removing
laundry
from
dryer.
j the dryer
before the end of the
All cycles
are cooled
slowly to reduced
wrinkling
and make it
cycle?
easier to handle.
Items removed
before
Cool Down may feel
very warm.
Was a high temperature
cycle
Select a lower temperature,
and use an automatic
drying
cycle.
used or was Dry Temp set on high?
These cycles
sense the temperature
or the moisture
level in the
load and shut off when the load reaches
the selected
dryness.
This reduces
overdrying.
k,.
j
13
