Cutting Crown Molding - DeWalt DW703 Manual De Instrucciones

90° approx. 1" longer than your final length then make
the miter cut as described above.
Right side
1. Position molding with bottom of the molding
against the base of the saw
2. Miter left 45°
3. Save the right side of cut
A third method of making the cut necessary is to make a
zero degree miter, 45 degree bevel cut. Your saw can cut
a bevel 6.1" wide.
CUTTING BASE MOLDING LAYING FLAT AND USING
THE BEVEL FEATURE
• All cuts made with the saw set at 45° bevel and 0 miter
• All cuts made with back of molding laying flat on the
saw as shown in figures 22 and 23.
• Move the left side fence out of the path of the blade
before attempting any of the following cuts.
INSIDE CORNER:
Left side
1. Position molding with top of molding against the fence
2. Save left side of cut
Right side
1. Position molding with bottom of the molding against
the fence
2. Save left side of cut
OUTSIDE CORNER:
Left side
1. Position molding with bottom of the molding against
the fence
2. Save right side of cut
Right side
1. Position molding with top of molding against the
fence
2. Save right side of cut

CUTTING CROWN MOLDING

Your miter saw is better suited to the task of cutting
crown molding than any tool made. In order to fit proper-
ly, crown molding must be compound mitered with
extreme accuracy.
The two flat surfaces on a given piece of crown molding
are at angles that, when added together, equal exactly 90
degrees. Most, but not all, crown molding has a top rear
angle (the section that fits flat against the ceiling) of 52
degrees and a bottom rear angle (the part that fits flat
against the wall) of 38 degrees.
Your miter saw has special pre-set miter latch points at
31.62 degrees left and right for cutting crown molding at
the proper angle. There is also a mark on the Bevel scale
at 33.85 degrees.
The chart below gives the proper settings for cutting crown
molding. (The numbers for the miter and bevel settings are
FIG. 25
FENCE
CROWN MOLDING FLAT ON TABLE AND AGAINST FENCE
FIG. 25A
BOTTOM SIDE
OF MOLDING
TOP SIDE
OF MOLDING
FENCE
CROWN MOLDING BETWEEN FENCE AND TABLE
very precise and are not easy to accurately set on your
saw.) Since most rooms do not have angles of precisely 90
degrees, you will have to fine tune your settings anyway.
PRETESTING WITH SCRAP MATERIAL IS
EXTREMELY IMPORTANT!
INSTRUCTIONS FOR CUTTING CROWN
MOLDING LAYING FLAT AND USING THE
COMPOUND FEATURES
1. Move the left side fence out of the path of the blade
before attempting any of the following cuts.
2. Molding laying with broad back surface down flat on
saw table (Fig. 25).
3. The settings below are for all Standard (U.S.) crown
molding with 52° and 38° angles.
12
FIG. 26
TABLE
FENCE
FIG. 27
DW 7084 CROWN
MOLDING FENCE
TABLE
FENCE
BEVEL SETTING
33.85°
33.85°
33.85°
BLADE
RIGHT
BLADE
WRONG
TYPE OF CUT
LEFT SIDE, INSIDE CORNER:
1. Top of molding against fence
2. Miter table set right 31.62°
3. Save left end of cut
RIGHT SIDE, INSIDE CORNER:
1. Bottom of molding against fence
2. Miter table set left 31.62°
3. Save left end of cut
LEFT SIDE, OUTSIDE CORNER:
1. Bottom of molding against fence
2. Miter table set left 31.62°
3. Save right end of cut