Register/De-Register A Handset; Register A Handset To A Topcom Butler 920 Base - Topcom BUTLER 920 Manual De Usuario

8 Register/de-register a handset

8.1 Register a handset to a Topcom Butler 920 base

You can subscribe up to 4 handsets to one base unit. By default, each
handset is subscribed on the base unit upon delivery.
You only need to subscribe the handset if:
• the handset subscription has been removed from the base unit (e.g. for
reinitialisation)
• you want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 920 handset
and base unit!
4 5 6
g h i j k l m n o
4 5 6
g h i j k l m n o
1
Press and hold the paging key on the base unit for 10
seconds.
The handset on charger LED on the base unit begins to
blink rapidly for 1 minute.
During this minute, the base unit is in register mode and
you must do the following to subscribe he handset:
2 Press and hold the right key for 3 seconds.
3 Press and hold the *-key for 3 seconds.
The following will appear on the display:
4
Enter the number of the base unit (1-4) you would like
to subscribe the handset to.
The unit will start searching for the base and when found,
it will ask to enter the PIN code (4 digits):
5 Enter the base PIN code (0000 by default). If the PIN is
wrong, the handset will restart the searching for the
base.
When the handset is registered, it will show "HS"
followed by the handset number.
Register/de-register a handset
19