Idiomas disponibles
Idiomas disponibles
OPERATION
R8723 IMPACT DRIVER
INSTALLING / REMOVING BITS
See Figure 4, page 11 (R8723).
To install bits, remove the battery pack from the tool.
Push the bit into the coupler until it clicks into place.
NOTE: If the bit does not insert easily into the coupler,
pull the coupler forward and reinsert the bit.
Pull on the bit to make sure it is secured in the coupler.
There may be some play in the installed bit; this is normal.
NOTE: Use only impact quality bits with a locking groove.
WARNING:
Make sure the bit is secured in the coupler before
using the impact driver. Failure to do so could
cause serious personal injury.
To remove bits, remove the battery pack from the tool.
With the nose of the tool pointed away from you, pull the
coupler away from the driver.
The bit will eject from the coupler.
LED LIGHT
See Figure 5, page 11 (R8723).
The LED light located on the front of the tool base illuminates
when the switch trigger is depressed.
If the tool is not in use, the time-out feature will cause the
lights to start fading and then shut off.
The LED light illuminates only when there is a charged battery
pack in the tool.
MAINTENANCE
WARNING:
When servicing, use only identical replacement
parts. Use of any other part could create a hazard
or cause product damage.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a 90-Day Satisfaction Guarantee Policy, as well as a
Three-year Limited Warranty. For Warranty and Policy details,
please go to powertools.ridgid.com or call (toll free) 1-866-539-1710.
NOTE: ILLUSTRATIONS BEGIN ON PAGE 10
USING THE IMPACT DRIVER
See Figures 6 - 7, page 11 (R8723).
NOTICE:
The impact driver is not designed to be used as
a drill.
WARNING:
Do not drive a screw where there is likely to be
hidden wiring behind the surface. Contact with a
"live" wire will make exposed metal parts of the
tool "live" and possibly shock the operator. If you
must drive a screw where hidden wires may be
present, always hold tool by insulated gripping
surfaces (handle) when performing the operation
to prevent a shock to the operator.
Check the direction of rotation selector for the correct
setting (forward or reverse).
Hold the impact driver with one hand.
Place the bit on the screw head, bolt head, or nut and
slowly depress the switch trigger. Start the bit slowly for
more control.
As the screw, bolt, or nut is driven, impacting will begin.
ELECTRIC BRAKE
The electric brake will stop the bit rotation after the operator
releases the switch trigger.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
9 - English
