Weather Station - Levenhuk Wezzer PLUS LP150 Guia Del Usuario

ATTENTION! When choosing the location for installing the outdoor sensor, keep in mind that the rain funnel
requires periodic cleaning. Place the sensor at least 1.5m away from buildings. Choose a place for it in an open
space with direct access to sunlight. For reliable data transmission, the distance between the sensor and the
weather station should be up to 150m. To avoid interference, make sure the sensor and the main base are
1–2m away from household devices operating on the same frequency.
• Pick a convenient location to install the 7-in-1 outdoor sensor. The kit includes mounting brackets for installment on
a vertical or horizontal surfaces, as well as on your own mounting pole.
• Lock the sensor in place tight to avoid it shaking in a windy weather, as it may negatively impact precipitation readings
accuracy.
• Tighten the mounting brackets (8) to the surface/wall using 4 included tapping screws, or attach the mounting pole to
your existing one with the included M5 bolts and nuts. Attaching to a mounting pole requires using the included rubber
pads.
• Install the outdoor sensor so that the rain funnel faces north and the solar panel faces south. Use a compass for precise
positioning.
• Use the bubble level (4) to horizontally level the sensor. If it's not level, the reading of UV and light intensity will be
inaccurate.
• To correct the horizontal level of the outdoor sensor, loosen the screws on the mounting pole (7). Adjust the level so that
the bubble is in the middle of the level, and tighten the screws.
• The standard direction for the wireless outdoor sensor is north, which provides the most accuracy in the Northern Hemi-
sphere. However, if you are located in the Southern Hemisphere, the sensor needs to be pointed to south.
• Select the STH mode in the clock settings (refer to the "Clock setup" section).

Weather station

• Plug the power adapter into the weather station power jack (9). Insert 3 AAA alkaline batteries for backup power, main-
taining the polarity.
ATTENTION! The DC adapter is recommended to power the main base. Batteries are used only as backup
power reserve.
Pairing with the wireless 7-in-1 sensor
• Once your weather station powers on, it should automatically search for and connect to the wireless sensors.
• If connection is not established within 10 minutes, retry pairing mode by removing and reinserting the power plug.
• You will see the blinking
process completes, the antenna icon will appear solid (not flashing), and the readings for outdoor temperature and hu-
midity, wind speed, wind direction, UV, light intensity, and rainfall will appear in their designated segments of the screen.
The station has entered normal display mode.
• If after a reset or reboot of the station the connection to the sensors fails, press and hold the CHANNEL button for
2 seconds to enter pairing mode. This will let the station automatically re-register sensors.
icon on the base screen, displayed in the temperature/humidity segment (1). Once the pairing
11