ORIGINAL OPERATING INSTRUCTIONS
ST 2500 / SD 2500 electric screwdriver
It is essential that the operating instructions
are read before the tool is operated for the
first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions
are with the tool when it is given to other
persons.
Operating controls and parts
Chuck
Protective sleeve (ST 2500 only)
Push-fit connection between depth gauge and
electric screwdriver
Control switch lockbutton
Supply cord
Control switch
Forward/reverse pushbutton
Depth gauge adjusting ring
Belt hook (SD 2500 only)
Contents
Printed: 07.07.2013 | Doc-Nr: PUB / 5070744 / 000 / 00
1. General information
1.1 Signal words and their meaning
-CAUTION-
Used to draw attention to a potentially dangerous situa-
tion which could lead to minor personal injury or damage
to the equipment or other property.
-NOTE-
Used to draw attention to an instruction or other useful
information.
1.2 Pictograms
Warning signs
General
warning
Obligation signs
Wear
eye
protection
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the operating
instructions.
In these operating instructions, the ST 2500 or SD 2500
electric screwdriver is referred to as "the tool".
Location of identification data on the tool
The type designation can be found on the rating plate and
Page
the serial number on the side of the motor housing. Make
1
a note of this data in your operating instructions and
2
always refer to it when making an enquiry to your Hilti
3
representative or service department.
5
6
7
Type:
8
8
8
9
Serial no.:
Warning:
electricity
Symbols
Read the
Wear
operating
ear
instructions
protection
before use.
en
1