Samsung WA41A3 A Serie Manual Del Usuario página 27

Ocultar thumbs Ver también para WA41A3 A Serie:
Idiomas disponibles

Idiomas disponibles

STEP 6 Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 pounds of laundry into the tub.
2. Press POWER to turn on your washer.
3. Select RINSE + SPIN by turning the Cycle Selector.
4. Press START/PAUSE to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to
the "STEP 2 Connecting the water supply hose" section on page 21 for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP
4 Leveling your washer" section on page 25 for instructions.
STEP 7 Run calibration (recommended)
Calibration ensures accurate weight detection by the washer. Make sure the tub is empty
before running calibration.
1. Press and hold Temp. and Power simultaneously.
2. Press Start/Pause to start calibration.
3. The tub rotates clockwise for approximately 2 minutes.
4. When complete, "0" appears on the display, and the washer turns off automatically.
NOTE
Run Calibration Mode periodically for more accurate weight detection.
DC68-03850F-04_IB_WA3000A_EN.indd 27
DC68-03850F-04_IB_WA3000A_EN.indd 27
English 27
2023-06-23
2023-06-23
11:52:35
11:52:35
loading

Este manual también es adecuado para:

Wa40a3 a serieWa40a3005awWa41a3000aw