Idiomas disponibles
Idiomas disponibles
10. The switch-on and switch-off times then appear in
the display "Time On / Time Off" (Fig. 10). It is not
necessary to press the "Check button" (6) again.
11. After a brief waiting time, "Time Mode" (Fig. 111)
appears in the display showing the time set.
10.5 "Always On Mode" (Fig. 12) (not recommended)
The pump can also be operated in Always On Mode.
There is no automatic safety shut-off in this mode and
therefore the pump may only be operated under con-
stant observation!
1.
Connect the pump to the power supply. The dis-
play shows "Standby Mode" (Fig. 3).
2.
Press the "Mode button" (4) several times until "Al-
ways On mode" is displayed (Fig. 12).
Attention: The pump starts immediately. Please
ensure that the product has been fully assembled.
3.
Press the "Mode button" (4) again to switch off the
pump. The display shows "Always On Mode" (Fig.
3).
11. Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
The customer's mains power connection as well as
the extension lead used must also comply with these
regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
26 | GB
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
The printing of the type designation on the connection
cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high start-
ing current (from 3000 watts)!
Connection type Y
If it is necessary to replace the mains connection ca-
ble, this must be done by the manufacturer or their rep-
resentative to avoid safety hazards.
AC motor 230 V~ / 50 Hz
Mains voltage 230 V~ / 50 Hz.
Mains power connection and extension leads must be
3-core = P + N + SL. - (1/N/PE).
Extension leads up to 25 m must have a minimum
cross-section of 1.5 mm². The mains power connection
must be protected with a max. 16 A fuse.
12. Cleaning and maintenance
m ATTENTION!
Only carry out maintenance, cleaning and adjustment
work when the mains plug is pulled out.
We recommend that you clean the product directly af-
ter every use.
Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic parts
of the product. Make sure that no water can penetrate
the motor.
• For a long service life, we recommend regular
checking and care.
• Before extended periods of inactivity or through
the winter, the pump should be thoroughly flushed
through with water, emptied completely and then
stored dry.
• If there is a risk of frost the pump must be completely
emptied.
• After longer periods of storage check the pump by
switching on/off briefly in order to check that the ro-
tor turns normally.
www.scheppach.com
