Idiomas disponibles
Idiomas disponibles
HOW TO USE SAW SAFELY
1. Use the pruning saw only with secure footing.
2. Hold the pruning saw at the right-hand side of
your body (See Fig. K).
K
3. The Chain must be running at full speed before
it makes contact with the wood.
4. Use the Base Plate to secure the saw onto the
wood before starting to cut.
5. Use the Base Plate as a leverage point while
cutting. (See Fig. L)
L
EN
L
6. Do not operate the saw with arms fully extended,
attempt to saw areas which are difficult to reach,
or stand on a ladder while sawing. (See Fig. M)
M
Never use the pruning saw above shoulder
height.
M
N
14
2
M
CUTTING WOOD UNDER TENSION (SEE
FIG. N)
WARNING: When cutting a limb that is under
tension, use extreme caution. Be alert for
wood springing back. When wood tension is
released, limb could spring back and strike
operator causing severe injury or death.
When sawing logs supported on both ends, start
the cut from above(Y) about 1/3 of the diameter into
the log (overbuck) and then finish the cut (Z) from
below, in order to avoid contact of the pruning saw
with the ground. When sawing logs supported on
only one end, start the cut from below (Y) about 1/3
of the diameter into the log (underbuck) and finish
the cut from above (Z) in order to avoid log splitting
or jamming of the pruning saw.
N
REMOVING A LIMB (SEE FIG. O)
P
1. Undercut the limb no more than 1/3 through
(33%).
2. Remove the limb from the top with a bucking cut.
3. Trim the remaining piece of the limb from the
tree.
O
3
CLEAN RESIDUAL OIL AFTER OPERATION
Lift the Chain Guard to the maximum position for 3
to 5 times. (See Fig.F2)
NOTE: The Oil Outlet cannot be faced towards
people. The Chain and Guide bar should be
faced down.
Z
Y
Y
Z
2
1
