Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING! Do not install the battery pack
before it has been completely assembled.
Always use gloves when handling the chain.
Maintain proper chain tension always. A loose
chain will increase the risk of kickback. A loose
chain may jump out of guide bar groove. This
may injure operator and damage chain. A loose
chain will cause chain, bar, and sprocket to
wear rapidly.
MOUNTING THE SAW CHAIN
1. Unpack all parts carefully. Remove the Drive
Cover by turning the Drive Cover Knob in a
counterclockwise direction. (See Fig. A1)
2. Place the pruning saw on a solid, level surface.
3. Use only genuine Kress Chains or those
recommended for Guide Bar.
4. Slide the Chain in the slot around the Guide Bar.
Ensure the Chain is in correct running direction
by comparing it to the chain icon on the Guide
Bar, or referring to the chain direction symbol
found on the saw body. (See Fig. A2)
A1
A1
EN
A2
A2
5. Fit the Chain onto the Drive Sprocket, so that
the Bar Stud and the Bar Locating Tab on the
Bar Pad fit into the keyway of the opening on the
B1
Guide Bar. (See Fig. B1, B2)
B1
10
1
1
2
2
1
1
B1
B1
B1
B2
B2
B2
F1
F1
1
1
1
6. Assure all parts are seated properly. Make
sure the drive links are fully seated in the Drive
C1
Sprocket (See Fig. C1), avoiding a kink as shown
in Fig. C2. If kink occurs, pick up the Chain at
C1
the Guide Bar just ahead of the kink and then
pull the kink out.
NOTE: Chain should rotate freely and be free
of kinks.
C1
F2
F2
C2
C2
Kink/Kink
C2
Pils
G1
Kink/Kink
G1
Pils
Kink/Kink
Pils
G
G
G
G
G
G
H
H
H
