Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
No power/no mist from
spout
Peculiar odor
Excessive noise
White dust accumulation
Red light illuminates above
the clean symbol
CAUTION: All servicing of this humidifier must be performed by authorized Homedics
service personnel only.
POSSIBLE CAUSE
• Unit is not plugged in
• Unit is not turned on
• No power at unit
• Low water level
• Transducer/
ultrasonic membrane
needs cleaning
• Float not installed
• Unit is new
• If unit is in use, the
odor may be a dirty
tank or old tank
water
• Unit is not level
• Low water level
• Hard water used
• Demineralization
cartridge needs to
be replaced
• Transducer/
Ultrasonic
Membrane needs
cleaning
• Clean reminder
needs to be reset
12
SOLUTION
• Plug unit in
• Press the power button to
turn the unit on
• Check circuits and fuses or
try a different outlet
• Refill the tank with water
• Follow Cleaning the
Transducer/Ultrasonic
Membrane instructions in
the How to Clean and Care
section
• Install float
• Remove the tank and let it air
out in a cool, dry place for 12
hours
• Empty the old water, clean
the tank, and fill with clean
water
• Place unit on a flat, even
surface
• Check the water level; refill
the tank if the water is low
• Use distilled water and a
demineralization cartridge
• Replace demineralization
cartridge
• Follow Cleaning the
Transducer/Ultrasonic
Membrane instructions in the
how to clean and care section
• Press and hold the timer and
night-light buttons at the same
time until the red light turns off
