Idiomas disponibles
Idiomas disponibles
B
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
The power supply should be connected in compliance with the relevant standard, or a single-
pole circuit breaker. The method of connection is shown below.
1. If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and that it
complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly qualified person.
WARNING:
The bottom surface and the power cord of the hob are not
accessible after installation.
Using the appliance
11
EN
