AL-KO COMBI-CARE 36 E comfort Traducción Del Manual Original De Instrucciones página 21

Maintenance and care
NOTE The motor switch bracket does not
lock in place. Hold it tight against the handlebar
during the entire working period.
Stopping the motor
1. Release the motor switch bracket (09/2). It
automatically returns to the initial position
(pos. c).
The motor stops immediately. The blade system
keeps running until it stops.
CAUTION! Danger of lacerations. There is
a danger of lacerations when reaching into the
blade system while it is running on.
■
Wait until the blade system has stopped.
6.6 Attaching and removing the grass
collector (10)
The appliance can be operated with and without
grass collector.
Attaching the grass collector
1. Raise the impact flap (10/1) (pos. a).
2. Attach the grass collector (10/2) in the hold-
ers (pos. b) from behind.
3. Release the impact flap.
Removing and emptying the grass collector
1. Stop the appliance and wait until the blade
system has stopped.
2. Raise the impact flap (10/1).
3. Lift the grass collector (10/2) out of the hold-
ers and take off to the rear.
4. Empty the grass collector.
5. Attach the grass collector (see above).
6.7 Moving the appliance on the grass (11)
Guide the appliance (11/1) over the grass (as
shown in the image) in such a way to avoid dam-
aging the mains cable (11/2). Heed the safety in-
structions (see chapter 3 "Safety instructions",
page 18).
■
Watch out for objects in the grass and re-
move them from the working area.
■
Guide the mains cable by hand.
■
Only control the appliance by the handlebar.
■
Move the appliance at walking speed.
■
Always move the appliance across the slope.
■
If the motor suddenly stops: The motor circuit
breaker has triggered due to an overload.
Wait a few minutes and then attempt to start
the motor again.
441970_c
■
In the following cases, visit the customer ser-
vice workshop:
■
Motor no longer starts.
■
Appliance has moved onto an obstruc-
tion.
■
Appliance vibrates and does not run
smoothly.
■
The blades of the scarifier roller or steel
spring prongs of the aeration roller are
bent.
7 MAINTENANCE AND CARE
CAUTION! Danger of lacerations. There is
danger of lacerations when reaching into the
blade system while it is running on or the stopped
blade system.
■
Stop the appliance and wait until the blade
system has stopped.
■
Disconnect the mains plug to power down the
appliance.
■
Wear protective gloves.
7.1 Cleaning the blade system
IMPORTANT! Danger from water. Water in
the appliance causes short-circuits and destroys
electrical components.
■
Do not spray the appliance with water.
■
Only use a broom or a brush for cleaning.
1. Stop the appliance and wait until the blade
system has stopped.
2. Disconnect the mains plug.
3. Remove the grass collector (see chapter 6.6
"Attaching and removing the grass collec-
tor (10)", page 21).
4. Tip the appliance onto the side and clean the
blade system with a broom or brush.
7.2 Replacing the scarifier or aeration
roller (12, 13, 14)
The scarifier roller is intended for coarse scarify-
ing work and the aeration roller for fine scarifying
work (see chapter 2.3 "Scope of supply",
page 16).
Removing the roller
1. Stop the appliance and wait until the blade
system has stopped.
2. Disconnect the mains plug.
3. Turn the underside of the appliance upwards.
4. Unscrew and lift out the socket head screws
(12/1) (pos. a).
21