Idiomas disponibles
Idiomas disponibles
The refrigerating system in this refriger-
ator is a "Frost Free" system. This type of
system requires no user intervention (i.e.
defrosting) other than selecting required
cooling temperatures and the usual care
and maintenance.
This unit is a FREE-STANDING INSTAL-
LATION ONLY, and is NOT intended to be
built-in. In the final installation location,
the unit's door must be able to open fully
and without posing any safety risk.LEVEL-
ING THE UNIT
It is very important to keep the unit level
so that the door will close properly and
prevent problems that will cause effec-
tive cooling to fail. To level the unit, turn
the adjustable legs clockwise or counter-
clockwise to raise or lower the corner.
Note: If the unit is not level, the door and
magnetic seal alignments will not be cov-
ered properly.
Note: To allow the doors to self-close, tilt
the top backwards by 3/8~5/8 inches..
Install this appliance in an area where the
ambient temperature is between 55°F
(13°C) and 110°F (43°C). If the temperature
around the appliance is too low or high,
cooling ability may be affected.
CLEANING BEFORE USE
Wipe the inside of the unit with a weak
solution of baking soda (bicarbonate).
Then rinse with warm water using a damp
sponge or cloth. Wash the shelves and
bins in warm soapy water and dry com-
pletely before putting back in the unit.
Clean the exterior of the unit with a damp
cloth.
GROUNDING INSTRUCTIONS
This appliance must be grounded. The
refrigerator must be plugged into its own
dedicated 115V/60Hz AC electrical outlet.
Performance may be affected if the volt-
age varies by 10% or more. Operating the
refrigerator with insufficient power can
damage the compressor. Such damage
is not covered under your warranty. The
power cord of the appliance is equipped
with a three-prong grounding plug for
your protection against electrical shock
hazards. It must be plugged directly into
a properly grounded three- prong recep-
tacle. The receptacle must be installed
When using a 3-pronged outlet
in accordance with local codes and or-
dinances. Do not use an extension cord
or adapter plug. You must make sure all
three prongs are in a 3-pronged outlet
(see figure).
3-pronged
plug
6
3-pronged
Receptacle
Receptacle
Box Cover
