Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Bevel cutting procedures
Bevel A ngle
Scale
Indicator
Fig. 23
WARNING:
When the workpiece is secured on the left or right side of the blade, the short cut-off
portion will come to rest on the right or left side of the saw blade. Always turn the
power off and let the saw blade stop completely before raising the handle from the
workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jam med against the saw blade causing fragments to scatter about
dangerously.
7. Co m pound cutting procedures
For co m pound cutting, follo w the instructions in paragraphs 5 and 6 above.
For m axim u m dim ensions for co m pound cutting, refer to " SPECIFIC ATIO N S " table on page 9.
CAUTION:
Always secure the workpiece with the right or left hand side for compound cutting.
Never rotate the table to the right for compound cutting (left bevel), because the
saw blade might then contact the clamp or vise that secures the workpiece, and
cause personal injury or damage.
Never rotate the table to the left for compound cutting (right bevel), because the
saw blade might then contact the clamp or vise that secures the workpiece, and
cause personal injury or damage.
8. Cro w n m olding cutting procedures
Fig. 24 sho ws tw o co m m on cro w n m olding types having angles of (θ) 38° and 45°.
For the typical cro w n m olding fittings, see Fig. 25.
A upper surface
θ°
B lo w er surface
Wall
The table belo w sho ws the miter angle and the bevel angle settings that are ideal for the tw o cro w n
m olding types.
NOTE:
For convenience, positive stops are provided for the miter setting (left and right 31.6°) positions.
For miter cut setting
If the table has been set to either of the angles described, m ove the table adjusting miter handle a little
to the right and left to stabilize the position and to properly align the miter angle scale and the tip of the
indicator before the operation starts.
For bevel cut setting
M ove handle on bevel section to the right and left and check that the position is stable and that the
bevel angle scale and the tip of the indicator are properly aligned. Then tighten the cla m p lever.
Cla m p
Lever
Loosen
Tighten
Pull
U p
Locating Bar
Ceiling
Fig. 24
(1) Loosen the cla m p lever and bevel the sa w blade to the
left or to the right.
W hen tilting the m otor head to the right, pull up the
locating bar as indicated in Fig. 23.
(2) A djust th e b ev el an gle to th e d esired settin g w hile
w atchin g th e b e v el a n gle scale a n d in dicator, th e n
secure the cla m p lever.
Ceiling
Wall
q
w
Fig. 25
e
r
English
17
Tabla de contenido
