Idiomas disponibles
Idiomas disponibles
EN
in this manual can only be carried out at our technical service centers.
3. Special safety instructions for the battery tool
a) Make sure the switch is in the off position before inserting the battery. The equipment will be damaged if you insert the battery
with the switch in the ON position.
b) The charger is designed for indoor use only.
c) Turn off the power when cleaning the charger to avoid damage.
d) Do not place the battery in areas of strong light. Do not place the battery on a hot surface. It will cause an explosion.
e) Allow the battery to cool completely before charging.
f) Do not disassemble the battery and avoid damaging it as it may cause personal injury.
g) Do not use a non-rechargeable battery.
4. Correct use of the charger
a) Use the charger only with rechargeable batteries. Otherwise, it will cause a fire or explosion. Please use the original charger
to keep safety.
b) Check the charger, cable and plug before use. In case of failure, go to a professional to repair it. For safety reasons, do not use
the charger if it is damaged or try to repair it yourself.
c) Check that the charger voltage is correct, otherwise you may be injured.
d) Disconnect power before turning tool on and off with battery and equipment connected.
e) Keep the charger clean and away from condensation and rain. Do not use the charger outside. Dirt and water can cause injury.
f) The charger is designed to be used with the original battery only. Otherwise, damage or fire may occur.
g) Avoid using a damaged charger as you may be injured.
h) Do not use the charger on a surface that could catch fire (for example, paper or dry objects).
i) Only a technician or professional service should replace the wiring.
j) The battery is not fully charged at the time of purchase, so it should be charged 4-5 hours before first use. Connect the battery
to the charger before turning it on and perform full charges periodically to extend its life.
k) Turn off the power once the battery is fully charged.
l) Normal charging time is 4-5 hours. Do not charge the battery for a long time as it may be damaged. Make sure the charging
indication shows a single LED, indicating adequate battery life.
5. Caution
Use the tool with caution, avoiding the following risks:
a) Damage from sharp surfaces.
b) Noise in the case of not wearing hearing protection.
c) Long operating times or illogical use of the machine could cause injury.
warning!
The equipment is an electromagnetic source, it can affect devices implanted in the body. Consult with your doctor
about its use. Do not touch the blade during its operation.
6
