Idiomas disponibles
Idiomas disponibles
EN
2. Cleaning
a) Do not rinse the tool or put it under water. It will cause a short circuit and damage it.
b) Keep the vent, motor and handle clean. Always clean the device with a duster. Do not use a cleaning device as it will rust the
parts.
c) Clean the blade after each use and protect it with oil or protective spray.
d) Open the front cover of the mower after it has been running for 8 hours to clean the impurities.
3. Sharp
This maintenance operation is very important to maintain the durability and correct condition of the blade.
The tool has an accessory to sharpen the blade. Check the blade beforehand and make sure it is in good working order.
4. Blade clearance adjustment
Check and adjust the blade gap to 0.1mm for easy cutting. Open the bracket with the screw. Turn the screw clockwise and adjust
the gap to 0.1mm.
14. storage
- Do not store the battery in a place where it is too cold or too hot.
- Remove the battery from the device if it is to be stored for a long time.
- Store the battery and charger in the box to keep them protected from heat, dust and moisture. Make sure the switch is in the
OFF position before storing the equipment.
The battery should be stored in a dry place:
Storage less than 1 month
Storage less than 6 months
Storage over 6 months
- Keep the battery. Fully charge it before storing it. Charge it every month if it is stored for a long time.
- Do not operate the switch during storage.
From -20ºC to +60ºC
From -10ºC to +35ºC
From 0ºC to +30ºC
12
