Idiomas disponibles
Idiomas disponibles
EN
10. Battery removal/mounting
1. Mounting
Make sure the mower, cord and battery are clean and dry. Assembly procedure:
Place the previously char-
1.
ged battery inside the har-
ness compartment.
NOTE: Before using the pruning shears, check that no one is around. For added safety, store it in the shoulder strap when not
in use.
11. environmental working conditions
1. Charge the battery in temperatures between 0ºC and 45ºC. The battery should only be operated at temperatures between
-10ºC and +60ºC.
2. During operation, the tool must be at temperatures between -5ºC and +30ºC.
1. Use
Wear suitable clothing and gloves when working with this tool. Always check tools before using them. Make
sure the power switch and safety switch are in good condition. The electrical current must be interrupted
if you release the trigger. Stop using the tool in case of switch failure. Check that the rated voltage of the
battery matches that of the mower. Please use the safety protection device to reduce the risks.
Check the working frequency of the blade. Maintain proper working conditions.
Turn off the machine, but be aware that it will take some time for the blade to stop. Make sure the blade is
completely stopped before touching it, otherwise you may be injured.
1. The direction of cable exit and the gripping direction of the trimmer.
2. It must be the same. Right-handed people can connect it to the right and left-handed people to the left.
3. Adjust the backpack and fasten the strap.
4. Connect the cable to the mower by tightening it.
5. Turn on the switch. After the warning sound, pull the trigger twice without holding it. The scissors will be in working status after
emitting one or more warning sounds. If the shears do not move during operation, check if the screw on the cable connecting the
shears to the battery is tight enough. If the screw becomes loose, tighten it and turn on the computer again. If the shears do not
move after operating for a long time and four warning beeps are heard, it is a sign that the battery is running low. In this case,
charge it immediately.
Connect the cable to the
2.
battery by snapping the pins
together.
Close and adjust the fixing
3.
strap.
10
Put on the harness and
4.
adjust it to the desired size.
