ERSA i-CON 2V MK2 Manual Breve página 32

Changing soldering tips
Activate the cursor by pressing the i-OP. Pressing again switches the cursor off
again.
With the cursor activated, turning the i-OP changes the value of the parameter.
7. Changing soldering tips
Never operate the soldering iron without the soldering tip! To avoid material dam-
age due to overheating, switch off the soldering station before changing the solder-
ing tip!
Risk of burns! Allow the soldering iron to cool off until reaching a safe temperat-
ure!
Touching the knurled plastic component of the soldering tip is always at your own
risk. If necessary allow the soldering tip to cool down completely before changing
it.
Attention Risk of burns!
After switching off, the soldering tip remains hot for a long time!
Risk of burns! The soldering iron gets hot immediately after it is switched on!
Never touch the hot soldering tip or the hot heating element directly!
Ersa GmbH
a) Switch off the soldering station by the mains switch.
CAUTION
CAUTION
CAUTION
3BA00270 | Rev. 1 15