Idiomas disponibles
Idiomas disponibles
3. DRAIN
1. Unscrew the hex screw on the bottom of the
jack and remove the spring with the two balls
(3.1).
2. Remove the oil from the jack.
4. PRODUCT PRESSURE RELIEF
1. Unscrew the hex screw on the bottom of the jack and remove the spring with the two balls
(4.1).
2. Suck out the ball that is in the hole with a magnetic rod to remove the air. The ball does not
have to get out of the hole (4.2).
3. Re-insert the spring with the balls.
PRECAUTIONS
•
For safety, the load may not exceed the maximum indicated weight: 500Kg
•
The center of the load has to be the same as the center of the hydraulic jack.
•
When it is elevated and you need to work under the hydraulic jack, use the safety tray.
•
Use synthetic oil for the cylinder is recommended. Check the level regularly.
•
If it is necessary to make movements with the hydraulic jack loaded, it must be done at the
lowest position.
•
Thoroughly lubricate the pieces removed to avoid oxidation.
IMPORTANT!
CAUTION! Not following this instructions can cause material damage
and damage to people. The improper use will break the warranty con-
tract. Save these instructions for new uses.
Make
sure
you
to avoid misuse with the hydraulic jack. Pay at-
tention to the security notes of the device. Use
it
correctly
and
· 5 ·
read
and
use
these
specifically
for
EN
instructions
the
use
it
has.
