Parkside PLS 3000 A1 Traduccion Del Manual De Instrucciones Originale página 37

3. Remove the carabiner (15) from the
eyelets (19). Release the collection bag
by pressing the locking button (8).
4. Open the zip-fastener on the collection
bag and empty it completely.
5. Mount the emptied collection bag
again.
Composting material does not be-
long with domestic waste!
Cleaning and
maintenance
Warning! Risk of injury by
dangerous moving parts!
Always clean the device
immediately after working with
it, as otherwise dirt will become
hardened and firmly attached
with leaf residues and might prove
impossible to remove without
dismantling the motor housing.
Such cleaning work is not covered
by the warranty.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing and remove
the mains plug
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
• Clean the collection bag (
brush and, if needed, compressed air.
General maintenance
• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Removal of clogging
A
and blockage
Leaf material and fresh plant parts may
clog / block the device.
Cleaning the impeller wheel:
Pull out the mains plug!
There is a risk of injury!
1. Open the protective cover (
remove the suction tube (
2. Carefully remove residues or clogging
materials from the impeller wheel.
3. Check to make sure the impeller wheel
is easier to turn and is in undamaged
condition. Have our Service Centre re-
place a defective impeller wheel.
GB MT
14) using a
A
7) or
A
16).
A
37