•
Exterior Wash Pro L
- Maximum power consumption: 150 W
- Maximum current draw: 1.5 A at 100-120 V~, 0.69 A at 200-240 V~
•
Exterior Wash Pro XL
- Maximum power consumption: 250 W
- Maximum current draw: 2.5 A at 100-120 V~, 1.13 A at 200-240 V~
Use only a source of AC power that complies with local building and electrical codes
and has both overload and ground-fault (earth-fault) protection.
Before using the fixture, check that all power distribution equipment and cables are
in perfect condition, are rated for the current requirements of all connected devices,
are protected to IP66 or higher and are of suitable type for the location (including
water, pollution, temperature and UV resistance).Disconnect the fixture from AC
power when not in use.
You may install micro lens accessories and install a Baffle Snoot as described in this
manual, but do not open the fixture or remove any cover. Refer any service
operation not described in this manual to an authorized Martin Service agent.
Shut down power to the entire installation at the main power distribution board and
lock out power before carrying out any installation or maintenance work.
Isolate the fixture from power immediately if any seal, cover, cable, or other
component is damaged, defective, deformed or showing signs of overheating. Do
not reapply power until repairs have been completed.
Protection from burns and fire
Do not operate the fixture if the ambient temperature (Ta) exceeds 45° C (113° F).
Above this temperature, the fixture regulates output to protect from overheating.
The surface of the product can become hot during operation. Avoid contact by
persons and materials. Allow the fixture to cool for at least 10 minutes before
handling.
Keep flammable materials well away from the fixture. Keep all combustible materials
(e.g. fabric, wood, paper) at least 10 cm (4 in.) away from the front of the fixture.
Ensure that there is free and unobstructed airflow around the fixture.
Do not illuminate surfaces that are closer than the following minimum distances from
the fixture:
•
Exterior Wash Pro QUAD and CTC S, M and L: 10 cm (4 in.)
•
Exterior Wash Pro QUAD and CTC XL: 40 cm (15.8 in.).
Do not attempt to bypass thermostatic switches or fuses.
Do not modify the fixture in any way not described in this manual or install other than
genuine Martin® parts. Do not stick filters, masks or other materials onto any lens or
other optical component. Use only accessories approved by Martin® to modify the
light beam.
The fixture's optical components can focus the sun's rays, creating a risk of fire and
damage. Do not expose the front of the fixture to sunlight or any other intense light
source.
Protection from eye injury
Do not look directly into the product's light output.
Do not look at the light output with magnifiers, telescopes, binoculars or similar
optical instruments that may concentrate the light output.
Ensure that persons are not looking directly into the front of the fixture when the
product lights up suddenly. This can happen when power is applied, when the
product receives a DMX signal, or when certain control menu items are selected.
®
8
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. D
