Protection from injury
Fasten the fixture securely to a fixed surface or structure when in use. The fixture is
not portable when installed.
To reduce the risk of strangulation, the flexible wiring connected to this fixture shall
be effectively fixed to the wall if the wiring is within arm's reach.
Exterior Wash Pro QUAD and CTC fixtures have the following weights (mounting
yoke included):
•
Exterior Wash Pro S: 4.8 kg (10.6 lbs.)
•
Exterior Wash Pro M: 7.4 kg (16.3 lbs.)
•
Exterior Wash Pro L: 12.1 kg (26.7 lbs.)
•
Exterior Wash Pro XL: 18.1 kg (39.9 lbs.)
Ensure that any supporting structure and/or hardware used can hold at least six (6)
times (or more if required by local regulations) the weight of all the devices they
support.
If suspending from a rigging structure, fasten the fixture to a rigging clamp. Do not
use safety cables as the primary means of support. If the fixture is installed in a
location where it may cause injury or damage if it falls, provide a secondary
attachment such as a safety cable inserted through the secondary attachment point
that will hold the fixture if a primary attachment fails. The secondary attachment
must be approved by an official body such as TÜV as a safety attachment for the
weight that it secures, must comply with DGUV 17 (BGV C1) or EN 60598-2-17
Section 17.6.6 and must be capable of bearing a static suspended load that is six
(6) times (or more if required by local regulations) the weight of the fixture and all
installed accessories.
The safety and suitability of lifting equipment, installation location, anchoring
method, mounting hardware and electrical installation are the responsibility of the
installer.
All fasteners used to mount fixtures must be suitable for the application, corrosion
resistant and strong enough to mount the fixture safely.
Block access below the work area and work from a stable platform whenever
installing, setting, adjusting, or cleaning the fixture.
After installation or service, check that the fixture and the trim frame or Baffle Snoot
are securely fastened.
Do not operate the fixture with missing or damaged covers, shields or any optical
component.
In the event of an operating problem, stop using the fixture immediately and
disconnect it from power. Do not attempt to use a fixture that is obviously damaged.
The fixture's Effective Projected Area (EPA) is as follows:
Exterior Wash Pro S
Exterior Wash Pro M
Exterior Wash Pro L
Exterior Wash Pro XL
®
10
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. D
Fixture
Fixture with
only
Baffle Snoot
0.024 m²
0.038 m²
0.048 m²
0.072 m²
0.084 m²
0.120 m²
0.144 m²
0.180 m²
