2. Pass two bolts with 8 mm (5/16 inch) shaft diameter through the 9 mm curved slots and fasten
them finger-tight into the mounting surface.
3. Adjust the aim of the fixture by turning it within the 60° of pan adjustment available, then fully
tighten all three bolts. If additional fasteners are required to mount the fixture safely, pass two
8 mm (5/16 inch) shaft diameter bolts through the 9 mm curved slots in the yoke base and fasten
them into the mounting surface.
To mount L and XL fixtures on a suitable surface:
1. See illustration below. Pass a 12 mm (1/2 inch) shaft diameter bolt through the 13.5 mm hole in
the center of the yoke base and fasten it finger-tight into the surface.
2. Pass two bolts with 8 mm (5/16 inch) shaft diameter through the 9 mm curved slots and fasten
them finger-tight into the mounting surface.
3. Adjust the aim of the fixture by turning it within the 60° of pan adjustment available, then fully
tighten all three bolts.
4. If additional fasteners are required to mount the fixture safely, pass two 12 mm (1/2 inch) shaft
diameter bolts through the 13.5 mm holes at the edges of the yoke base and tighten them into the
mounting surface.
Securing with a safety cable
If regulations require it, the fixture can be secured with a safety cable that is approved for the weight of
the fixture and mounting hardware.
To secure the fixture with a safety cable:
1. Obtain an Exterior Wash Pro Safety Cable Attachment Bracket from your Martin supplier. Fasten
this bracket (arrowed) securely to the bottom of the fixture as shown in the illustration below using
the screws supplied with the bracket.
®
32
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. D
Figure 2. Mounting yoke base, L and XL fixtures
