Technical Support
If you have any questions about how to install or operate the fixture safely, please
contact Harman Professional Technical support.
For technical support in N. America, please contact
Phone: (844) 776-4899
For technical support outside North America, please contact your national
distributor.
Read this manual before installing, powering or servicing the fixture. Follow the
safety precautions and observe all warnings in this manual and printed on the
fixture.
The latest version of this manual is available for download from the Exterior Wash
Pro pages of the Martin® website at www.martin.com. Before you install, operate or
service an Exterior Wash Pro family fixture, check the Martin website and make sure
that you have the latest user documentation for the fixture. Document revisions are
indicated at the bottom of page 2.
Install, operate and service Martin products only as directed in their manuals, or you
may create a safety hazard or cause damage that is not covered by product
warranties. Keep this manual for future use.
Protection from electric shock
This fixture is IP66 rated. It is suitable for use in wet locations, but do not immerse it
in water or install it in a location where it may become submerged. Ensure sufficient
drainage to cope with the heaviest rainfall. Make sure that water can drain away
from the installation area at least as fast as it can enter it.
Do not allow water to collect on or near the pressure equalization valve located on
the rear of the fixture between the cable entries. Do not install a fixture with the
valve membrane horizontal so that water can pool on it. Do not cover, immerse or
block the valve. Check the valve periodically. If it appears dirty, it may be becoming
blocked. Contact an authorized Martin service agent for possible replacement.
Arrange cables so that they arrive at connectors from below. Create a 'drip loop' if
necessary. With this arrangement, gravity will cause any condensation or water
droplets to run away from connectors.
Support the weight of cable runs. Do not allow a length of cable to hang from a
cable gland or connector.
This fixture is a Class I product according to IEC 61140. Ensure that the fixture is
electrically connected to ground (earth) via the fixture's mains power cable.
The DMX and Ethernet transceivers of the fixture are isolated/SELV to prevent
ground loops and for safety reasons.
This fixture accepts AC mains power within the ranges 100-120 V~ and 200-277 V~
nominal at 50 or 60 Hz only. Do not connect it to power at any other voltage or
frequency.
Exterior Wash Pro QUAD and CTC fixtures have the following AC mains power
characteristics:
•
Exterior Wash Pro S
- Maximum power consumption: 35 W
- Maximum current draw: 0.35 A at 100-120 V~, 0.16 A at 200-240 V~
•
Exterior Wash Pro M
- Maximum power consumption: 75 W
- Maximum current draw: 0.75 A at 100-120 V~, 0.35 A at 200-240 V~
®
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. D
7
