Testing
Exterior Wash Pro fixtures are programmed with a test
sequence that is activated by 'swiping' (moving) a
magnet past a magnetic switch inside the fixture. The
magnetic switch is located on the rear of the fixture. A
magnet icon is provided on the housing to show the
switch location.
Exterior Wash Pro QUAD models
Swiping a magnet past the magnetic switch causes the
fixture to step through the following sequence:
1. Display status code (see table below for meaning).
2. All LEDs at full intensity.
3. All red LEDs at full intensity.
4. All green LEDs at full intensity.
5. All blue LEDs at full intensity.
6. All white LEDs at full intensity.
7. Exit sequence and resume normal operation.
You can also resume normal operation by cycling power off and on. If you are sending a DMX signal
to the fixture, it will exit the sequence and enter normal DMX operation again after a short period.
Fixture status is indicated as follows:
LED color
Blue
Blue
Green/blue
Exterior Wash Pro CTC models
Swiping a magnet past the magnetic switch causes the fixture to step through the following sequence:
1. Display status code (see table below for meaning).
2. All LEDs at full intensity.
3. All cold white LEDs at full intensity.
4. All medium white LEDs at full intensity.
5. All warm white LEDs at full intensity.
6. Exit sequence and resume normal operation.
You can also resume normal operation by cycling power off and on. If you are sending a DMX signal
to the fixture, it will exit the sequence and enter normal DMX operation again after a short period.
Fixture status is indicated as follows.
LED color
Cold
Cold
Cold/warm
®
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. D
Signal
Status
Fast flash
Busy (booting or uploading SW)
Slow flash
No DMX detected
Alternating
Running normally in DMX mode
Signal
Status
Fast flash
Busy (booting or uploading SW)
Slow flash
No DMX detected
Alternating
Running normally in DMX mode
63
