2. See A in Figure 5. Loosen the captive screws from both sides of the trim frame (or Baffle Snoot, if
used) on the front of the fixture by pressing them in and turning them clockwise until they reach a
stop.
3. See B. Using the Exterior Multitool available from Martin or a similar tool with no sharp edges,
lever the trim frame carefully away from the fixture. Avoid damaging the fixture housing, seal or
trim frame.
4. See C. Remove the screws from the filter holder on the front of the fixture and remove the filter
holder (the number and positions of the screws varies depending on fixture).
5. See D. Position the microlens (arrowed) in the recess provided for it in the front of the fixture,
making sure that the marking 'This side out' close to the edge of the microlens faces outwards,
towards the front of the fixture. Re-install the filter holder, tightening the screws evenly. Make sure
that the microlens remains in position while installing the filter holder.
6. Re-install the trim frame (or Baffle Snoot, if used) and fasten it in place with its two captive screws.
Press each screw in and turn it counter-clockwise until it reaches a stop. Check that the trim frame
is held securely.
A
In S, M and L fixtures, it is possible to use an asymmetric microlens to modify the orientation of the
beam's wide/narrow configuration to angles other than 90° by ordering a microlens for the next size
fixture up and cutting it to shape with the microlens at an angle.
Installing a Baffle Snoot
The optional Baffle Snoot accessory for Exterior Wash Pro fixtures may be installed with or without a
microlens (see previous page).
To install a Baffle Snoot accessory:
1. Shut down power to the fixture and allow it to cool.
2. Refer to the illustration on the next page. See A. Loosen the two captive screws (arrowed) in the
sides of the trim frame on the front of the fixture by pressing them n and turning them clockwise
until they reach a stop.
3. See B. Using the Exterior Multitool available from Martin or a similar plastic tool with no sharp
edges, lever the trim frame carefully away from the fixture. Avoid damaging the fixture housing,
seal or trim frame.
4. See C. Lift the trim frame up as shown, remove the screw (arrowed) from the safety wire and
release the wire from the trim frame. Set the trim frame aside for storage and possible future re-
use.
5. See D. Hold the snoot up to the front of the fixture. Fasten the safety wire to the snoot re-using the
safety wire's screw (arrowed).
®
34
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. D
B
Figure 5. Microlens installation
C
D
