Idiomas disponibles
Idiomas disponibles
12. Adjust the four leg clamps so that they
are at roughly the same height.
Insert a longitudinal support bar(4) through
a leg clamp on a front leg, insert two
battery clamps over the bar, then insert the
longitudinal bar through the leg clamp on
the rear leg. Adjust the height of the front
and rear leg clamps, so that the longitudinal
bar is level. Tighten the clamp bolts against
the beam to secure it.
Repeat
for
the
support bar.
Note that the stand is designed to fit the
FM5, FM8 & FM10 log splitters, therefore the
longitudinal beam will protrude on the FM5
& FM8. You can cut the beam to length if you
wish using a standard hacksaw.
The log splitter can now be rotated to the
upright position from the position in which
the stand has been assembled. Depending
on which splitter you have , this may require
two persons.
Adjust the postion of the four battery clamps to securely hold you battery then tighten all the battery
clamp bolts.
Brake Pin
38
remaining
longitudinal
Thumbscrew
13. To stop the log splitter moving when in use.
Loosen the thumbscrew and slide the brake pin
until it protrudes through one of the holes in the
wheel hub.
This should be done with at least one brake pin
on each axle.
FM5, FM8 & FM10 (Versions D, T & TW)
