Forest-Master FM5D Manual Del Usuario página 11

Attach the work bench to the log rail mounting points using the M6x16 cap head bolts, M6 spring
washers, M6 flat washers. There are 4 mounting points but note that one of the rear mounting points
is for the long rear bracket, which is attached in the next step. Do not fully tighten the bolts until after
the next step.
FM5, FM8 & FM10 (Versions D, T & TW)
Flat Washer
Spring Washer
M6x16 Cap Head
Fit the long rear mounting bracket to the inside face of
the long rear edge of the work bench and the rear guard
panel to the outside face, using 2 M6x16 cap head bolts,
4 M6 flat washers and 2 M6 nyloc nuts. Then attach the
rear bracket to the mounting point on the splitter using
an M6x16 cap head bolt, M6 spring washer and M6 flat
washer. You should now fully tighten the bolts holding the
tray to the log splitter.
11