Idiomas disponibles
Idiomas disponibles
Notes: Left chart is available for the position of drain hose, refer
to Fig. 7. Right chart is available for the position of drain hose,
refer to Fig. 9.
Rightward
Downward
Drain hole
Installation
board
Wall
Left
back
Fig 8
OUTDOOR UNIT INSTALLATION
• If installation brackets for
installing the outdoor unit are
needed, the user could buy
them from our company or
agents (Fig. 1 0).
• Assemble the mounting
frame and supports using
the 6 screws (M12x25), plain
washers, spring washers, and
nuts provided.
• Drill 4 or more holes on the wall according to the feet size of
the air conditioner. Determine the locations for mounting left
and right supports. Ensure that the left and right supports are
at the same height and levelled.
• Attach the installation frame to the wall with expansive bolts.
• Fix the outdoor unit with 4 bolts (M10x25) on the installation
brackets.
• Fittings must be tightly screwed and the connection must be
tight and reliable.
• When installing the outdoor unit, its body should be hung with
ropes to prevent it from falling.
• When installing or repairing, tools and components should be
prevented from falling.
• Regularly check the reliability of the installation frame.
TUBING CONNECTION
• Detach the valve cover of the outdoor unit.
• Align the flaring nut to the thread centre, and tightly screw the
nut by hand.
• Tightly screw the flaring nut with a torque wrench until the
torque wrench produces a 'click' sound.
• It is recommended to use a torque wrench to connect the
tubing. If other flexible or fixed wrench is used, it may damage
the horn mouth due to improper torque.
• The bending angle of the tube should not be too small, other-
wise the tube may break. As such, the service personnel should
use a tube bender to bend the tube.
4
Leftward
Right back
Fig 7
Drain
hole
Fig 9
Installation support
Fig 10
• Never let water, dust or sand get into the pipe.
Thread
Wrench
Fig 11
Tubing size(mm/inch)
6(1/4")
9.52(3/8")
12(1/2")
15.88(5/8")
19.05(3/4")
WIRE CONNECTION
1. Indoor unit (fig. 1 2)
• Open the panel by lifting
it upwards and directly to
the maximum position.
• Open the electrical
component cover.
• Secure the connection
wires to the terminal
block according to the
wiring diagram on the
electrical component
cover.
• Press the connecting wire tightly with the pressure plate.
• Close the electrical component cover, secure the electrical cover
with screws, and close the panel.
Note: Some models may have wires that cannot pass directly
through the cable hole into the electric control box, and the
above steps need to be removed after removing the middle
frame.
2. Outdoor unit (fig. 1 3)
• Unscrew the handle
cover fixing screw and
open the handle cover.
• Secure the connection
wires to the terminal
block according to the
wiring
• Press the connecting
wire tightly with the
pressure plate.
• Reinstall the handle
cover and fasten it with
the screws.
• If customers need to
extend or replace the
power cord, please
refer to Table 3 for
specifications.
Flaring nut Pipeline
Torque Wrench
Torque(N.m)
15~20
35~40
50~55
60~75
80~95
Electric cover
Wiring diagram
Fig 12
Handle cover
Wiring
diagram
Screw
Fig 13
Open
Close
