Idiomas disponibles
Idiomas disponibles
Installing Fan to
the Electrical Box
WHEN MOUNTING ON A SLOPED CEILING,
MAKE SURE THE MOUNTING PLATE SLOTS
ARE ON THE LOWER SIDE BY SLIDING THE
MOUNTING BRACKET FROM THE TOP DOWN.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket
as shown in Figure 8.
2. Attach the ceiling mounting bracket on the
electrical box by sliding the mounting brack-
et over the two screws provided with the
electrical box. When using close-to-ceiling
mounting, it is important that the mounting
bracket be level. If necessary, use leveling
washers (not included) between the mount-
ing bracket and the electrical box. Note that
the flat side of the mounting bracket is to-
ward the electrical box (Figure 8).
3. Securely tighten the two mounting screws.
4. Carefully lift the fan assembly up to the ceil-
ing mounting bracket and hang the fan on the
hook provided by utilizing one of the holes
at the outer rim of the ceiling canopy (Fig-
ure 12). If using standard mounting, seat the
hanger ball in the mounting bracket socket.
Make sure the tab on the mounting bracket
socket is properly seated in the groove in the
hanger ball (Figure 12).
6.
THE HOOK AS SHOWN IN FIGURE 12 IS ONLY
TO BALANCE FAN WHILE ATTACHING WIRING.
FAILURE TO HANG AS SHOWN IN FIGURE 12
MAY RESULT IN HOOK BREAKING, CAUSING
THE FAN TO FALL. HOOK MUST PASS FROM
INSIDE TO OUTSIDE OF CANOPY
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT USE A SOLID STATE SPEED
CONTROL WITH THIS FAN. IT WILL PERMA-
NENTLY DAMAGE THE ELECTRONIC CIRCUIT-
RY.
1. Connect the ground conductor of the 120v
supply (this may be a bare wire or a wire
with green colored insulation) to the green
ground lead(s) of the fan (Figure 13). When
using standard ceiling mounting, there are
two green grounding leads; one from the
Figure 12
ceiling mounting bracket and one from
the ball/downrod assembly. When using
"Close-to-Ceiling" mounting, there is only
one green ground lead from the ceiling
mounting bracket since the ball/downrod
assembly is not used.
2. Connect the fan motor white wire to the
supply white (neutral) wire using a wire nut
(Figure 13).
3. Connect the fan light supply (blue) wire and
the fan motor black wire to the supply black
(hot) wire using a wire nut (Figure 13).
4. Turn wire nut connections upward, spread-
ing them apart so the green (ground) and
white wires will be on one side of the elec-
trical box and the black and blue wires will
be on the other side, and push into the elec-
trical box.
