Idiomas disponibles
Idiomas disponibles
Hanging the Fan
REMEMBER
to
turn
er. Follow the steps below to hang your
fan properly.
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling mounting using the downrod with
ball and socket installation, and the "close-
to-ceiling" mounting. The "close-to-ceiling"
mounting is recommended in rooms with
less than 8-foot ceilings or in areas where
additional space is desired from the floor
to the fan blades. When using standard
downrod installation, the distance from the
ceiling to the bottom of the fan blades will be
approximately 12 inches. The "close-to-ceiling"
installation reduces the distance from the
ceiling to the bottom of the fan blades to
approximately 8 inches.
Once you have decided which ceiling
installation you will use, proceed with the
following instructions. Where necessary,
each section of the instructions will note the
different procedures to follow for the two
types of installation.
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. MAKE
SURE THE MOUNTING BRACKET SLOTS ARE
ON THE LOWER SIDE BY SLIDING THE MOUNT-
ING BRACKET FROM THE TOP DOWN.
4.
Standard Ceiling
Mounting
off
the
pow-
1. Loosen the two set screws in the collar on
the top of the motor assembly (Figure 7).
2. Remove the canopy ring from the canopy
by turning the ring to the right until it un-
locks (Figure 5).
3. Remove the mounting plate from the cano-
py by loosening the four screws on the top
of the canopy. Remove the two non-slotted
screws and loosen the slotted screws. This
will enable you to remove the mounting
bracket (Figure 6).
4. Route the wires exiting the top of the fan
motor through the decorative motor collar
cover then the canopy ring. Make sure the
slot openings are on top. Route the wires
through the canopy and then through the
ball/downrod assembly (Figure 8).
5. Align the holes at the bottom of the down-
rod with the holes in the collar on top of
the motor housing (Figure 8).
6. Carefully insert the hanger pin through the
holes in the collar and downrod. Be care-
ful not to jam against the wiring inside the
downrod. Insert locking pin and bend to
ensure security.
7. Tighten the two set screws on top of the
fan motor firmly (Figure 7).
8. Proceed to "Installing Fan to Electrical
Figure 5
Box" section on page 6.
FAILURE TO PROPERLY INSTALL CLEVIS PIN
AS NOTED IN STEP 6 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Figure 6
Figure 7
