Attaching The Fan Blades; Hanging The Fan - HAMPTON BAY Minorca Manual Del Propietário

Attaching the
Fan Blades
NOTE: Your fan blade are reversible. Select the
blade side finish which best accentuates your
decor.
1. Attach blade to blade bracket using the
screws supplied (Figure 5). Start a screw
into the bracket. Repeat for the two remain-
ing screws.
Screws
Blade
Blade Bracket
2. Tighten each screw securely.
3. Rotate the center flywheel until the blade
bracket screw holes in the center flywheel
are visible from the cut-out in the top light
kit plate (Figure 6).
4. Insert the blade/blade bracket assembly
through the hole in the side of the center
fly wheel, align the two screws holes in
the blade bracket with the screw holes in
4.
the center flywheel and secure with screws
supplied (Figure 6).
Screws
Center
Flywheel
Hole For Blade
Bracket Insert
5. Repeat steps 1-4 for the remaining blades.

Hanging the Fan

REMEMBER
er. Follow the steps below to hang your
fan properly.
Figure 5
NOTE: This fan is recommended for the stan-
dard ceiling mounting using the downrod with
ball and socket mounting. When using stan-
dard ceiling installation, the distance from the
ceiling to the bottom of the fan blades will be
approximately 16 inches.
THE FAN MUST BE MOUNTED WITH A
MINIMUM OF 7 FEET CLEARANCE FROM
THE TRAILING EDGE OF THE BLADES
TO THE FLOOR.
Cut-Out In The
Top Light
Kit Plate
Blade/Blade
Bracket
Assembly
Figure 6
to turn off the pow-
IF YOU FEEL THAT YOU DO NOT HAVE
ENOUGH ELECTRICAL WIRING KNOWL-
EDGE OR EXPERIENCE, HAVE YOUR
FAN INSTALLED BY A LICENSED ELEC-
TRICIAN.
1. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks (Figure 7).
Turn Canopy Ring To Remove
2. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove the
mounting plate (Figure 8).
Loosen But Do
Not Remove
Figure 7
Remove
Figure 8