Hitachi ATW-IOT-01 Manual De Instrucciones página 12

INSTALLATION
1. Disconnect the main power from the
system.
To ensure your safety, always make
sure main power is switched off
before accessing wiring.
2. Remove the cover from the receiver.
3. Mount the wiring plate to the wall
or wallbox.

NOTE
The plugs and mounting screws required are
supplied.
4. Connect the receiver wiring.
• Connect the H-LINK cable.
• Place the cable through the orifice
identified by marker 3.
• Connect the power cable
(L = Live; N = Neutral) (Tightening
torque 0.50N·m)
• Place the power cable in the cable
guide identified by marker 1.
EN
PMML0635 rev.3 - 04/2024
5. The cables must be positioned in
the box's cable guides in order to
guarantee the pull-off strength.
L N
1~ 230V 50Hz
L
CB
N
Item
Circuit Breaker 5A
CB
Cable
(1) Power cable type cannot be lighter than the
specified in 60245 IEC 57.
6. Attach the cover of the receiver to
the wiring plate.
7. Reconnect the mains power to the
system.
8. Download the CSNET Home
application from Apple store or Play
store. Application is also available on
www.csnetmanager.com.
3.1 Dimensional data
98
ATW-IOT-01
H-LINK
YUTAK
YUTAKI
1 2
Terminal
Termina
board
Board
H-LINK
Notes
2 x 0.75
(1)
80,79
2