Idiomas disponibles
Idiomas disponibles
Hold power tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord.
When ripping always use a rip fence or straight edge guide.
Always use blades with correct size and shape (diamond versus round) of arbour holes.
Never use damaged or incorrect blade washers or bolt.
7 CAUSES AND PREVENTION OF KICKBACK
A kickback is the sudden reaction as a result of a stuck, jammed or misaligned saw blade
which leads to an uncontrolled saw to be lifted and moved from the workpiece out in the
direction of the operator.
A kickback can occur when the saw blade gets stuck or jammed in the saw gap. The saw
blade is blocked and the motor force repels the circular saw in the direction of the
operator.
A kickback can occur when the saw blade becomes twisted or misaligned in the saw
groove. As a result, the teeth of the back edge of the saw blade can get stuck in the
surface of the workpiece, whereby the saw blade is moved out of the saw gap and the saw
jumps back in the direction of the operator.
A kickback is the result of incorrect or faulty use of the saw. It can be prevented by
appropriate precautions as described below.
Hold the saw firmly and bring your arm into a position in which you can resist the kickback
forces. Always hold the saw blades on the sides, never bring the blade in line with your
body. In a kickback, the saw can jump backwards, but the operator can control the
kickback forces if appropriate measures were taken.
If the saw blade jams or sawing is interrupted for any reason, release the ON / OFF switch
and calmly hold the saw in the material until the saw blade stands completely still. Never
attempt to remove the saw from the workpiece or pull it backwards as long as the saw
blade is moving or a kickback might occur. Find the cause of the saw blade jam and
eliminate them through appropriate measures.
When you want to restart a saw that is stuck in a workpiece, center the saw blade in the
saw gap and check that the saw teeth are not stuck in the workpiece. If the saw blade
jams, it can move out from the workpiece or a kickback can happen if the saw is restarted.
Prop up large panels in order to minimise the risk of a kickback by a jammed saw blade.
Large panels tend to sag under their own weight. Panels must be supported on both sides,
both in the vicinity of the saw gap as well as on the edge.
Do not use dull or damaged saw blades. Saw blades with blunt or misaligned teeth cause
increased friction, jamming of the saw blade and kickback by an excessively narrow saw
gap.
Tighten the cutting depth position prior to cutting. If the settings change while cutting, the
saw blade can jam and a kickback can occur.
Be especially careful if you perform a "circular cut" in a hidden area, such as an existing
wall. The protruding saw blade can get blocked in hidden objects while cutting and cause
a kickback.
Do not place the saw on the workbench or the floor unless the saw blade is at a standstill.
An unprotected, running saw blade moves the saw against the cutting direction and cuts
whatever is in its way. Thus note the delay time of the saw.
For this reason, the saw is not suitable for use in reverse position as fixed equipment.
Do not operate the saw if it is not working properly or has been damaged. In case of
technical problems, do not attempt to repair it on your own. Contact the service or have
the saw repaired by a professional.
Copyright © 2016 VARO
POWX1410
P a g e
| 5
EN
www.varo.com
