Idiomas disponibles
Idiomas disponibles
USER AND INSTALLATION MANUAL
3.
OPERATION
FUNCTIONS
The air conditioner can be controlled using the remote control. Two AAA batteries are required.
NOTE: You will find more information about the functions on the next page.
POWER
MODE
FAN SPEED
TIMER
44
Press "POWER" to turn the unit On or Off.
Press to change between the 4 different modes. The display will show the symbol for
the mode currently selected.
The cooling function allows the air conditioner to cool the
room and at the same time reduces air humidity. The desired
temperature can be adjusted using the increase and decrease
button between 16°C and 30°C. The fan speed can also be
COOLING
adjusted using the speed button.
Dry mode will extract moisture from the air, which will be drained
outside using the installed drain pipe. the fan speed cannot be
adjusted in dry mode.
DRY
In fan mode the appliance will recirculate the air within the
room, and will not cool, heat or dehumidify. The fan speed can
be adjusted using the Speed button, But the desired temperature
FAN
can not be set.
The heating function allows the air conditioner to heat the room.
The desired temperature can be adjusted using the increase and
decrease button between 16°C and 30°C. The fan speed can also
HEATING
be adjusted using the speed button.
Silent mode can be activated from APP or the remote control, It
can also be activated by pressing "
panel at the same time. It will only operate in cooling or heating
modes, the fan speed will change to low and noise will be lower.
SILENT
Press to change the fan speed between Low, Medium and High.
The fan speed cannot be adjusted in Dry or Silent modes.
The air conditioner contains a 24 hour timer, which can be used to either set a delayed
start, or a set period of operation.
SHUTDOWN TIMER:
While the unit is running press the timer button, the display will flash "0" 5 times.
After the 5th flash, use the up and down buttons to adjust the duration in 1 hour
increments between 1 to 24 hours. When the timer has elapsed, the unit will shutdown
automatically.
DELAYED START TIMER:
With the unit in standby, press the timer button, the display will flash "0" 5 times. After
the 5th flash, use the up and down buttons to adjust the duration in 1 hour increments
between 1 to 24 hours. After the timer has elapsed, the unit will start up in the same
mode with the same settings as when it was turned off.
MONOBLOCK UNIG
" + "
" on unit control
