Idiomas disponibles
Idiomas disponibles
vvww.GEAppliances.com
Fan Switch
To reach
tile tim switch
(es)
remove
tile
front
grille.
On HeagCool and Heat Pump models, tile tim switch
leveI_ are located
in holes accessed
through
tile
control
box. Tile top switch is fin" COOL settings
and tile bottom
sMtch is fin" H_lTsettings.
Use a small screwdriver
to change
tile setting.
Tile trait is shii)ped
fl'Oll/ tile ti_ctory set ill tile
CONY setting tot COOLand in tile cgCtfsetting
tot HEAT
Cool only models
have
a rocker
switch
on tile
front
of tile control
box.
_4qlen set at CYCLE (down)
tile tim cycles on and
off when
cooling.
When
set at CONT (continuous,
up) tile tim runs all tile time, providing
a more
balanced
telnI)eramre.
Tile unit is shipped
ill
tile CONTsetting.
Temperature Limiting
Limiting
tile maMmum
and minimum
settings
prevents
useI_ ti'oln turning
tile control
to tile
extrelne
heat or cool positions.
Tile nom/al
range
of tile temp control
is
approxinmtely
60°F to 85°E Tile control
range
may be narrowed
by tile use of tile telni)erature
lilniting
screws located
behind
the control
panel.
. %.
Limits @
Limits
heat
cool
temp
temp
Each position equals approximately 3°E
Vent Control
Tile vent control
is located
behind
tile fl'ont
grille on tile fight side of tile air discharge
area.
X'_qlell set at CLOSE,onl} tile air inside
tile room
will be circulated
and conditioned.
When
set at
OPEN, some inside
air is exhausted
outside.
To
open
or
close
tile
vent:
1. Relnove tile fl'ont grille.
2. Relnove
tile vent card screw.
3. Relnove vent card, turn it over and replace
it by locating
rear hole in card over locating
pin inside air dischmge
and ream_ching
scFew
at Ji'ollt.
Ti_eunit leavesthefactorysetat the CLOSE position.
_hole
OPEN position
(Meshendtowardhack)
Screwhc
CLOSE position
(Meshendtoward front)
A# Direction
HolJzontnl
lo/wei_
on tile fl'ont grille
let you control
tile
air direction
up
and
down.
Reln_we tile fl'ont
grille to a(!iust the
vertical
louve_
side-to-side
to
direct
the air lett
or fight.
