Idiomas disponibles
Idiomas disponibles
Installation
Instructions
WINDOW
INSTALLATION--OPTIONAL
(cont.)
[] INSTALL CASE IN WINDOW
[]
Peel off the backing from the bottom
window
gasket.
[]
Place the gasket on the stool and over the
brackets,
even with the rear edge, sticky
side down.
L
]
Bottom window gasket
[]
Carefully
slide the empty
case into the
window
until the holes in the case line up
with the holes in the panel angles.
Case holes
!l
I!
NOTES:
• The case should
have a 1/8" minimum
tilt
toward
the outside.
• Be sure the seal gasket and panel gaskets
remain
in position
and do not roll with the
case.
[]
Lower the window
so it fits behind the panel
tabs. Insert the 4 type A screws through
the
holes in the case and into the panel angles,
2 on each side.
ta bs
Case
screws
[]
With the window
closed,
mark where
the
window
sash meets the case.
[]
Peel offthe
backing
from the case top gasket.
[]
Hold on to the case, open the window,
and
place the gasket along the mark on the case.
Put the gasket
on top of the
case where
the window
will close.
[]
Place the vinyl window
gasket over the case top
gasket. Insert the panel tabs through
the slits in
the gasket. Cut the gasket on each side to the
width
of the window.
[]
Close the window
tightly
on the vinyl gasket.
Bend the gasket forward
to expose the panel
tabs. Drill pilot holes into the window
sash,
_Attach
the panel tab
to the window on
each side with a type
D screw.
2O
