Maintenance - Fenix TRC-700 Instrucciones

rim of the plate (I), then raise the sections
vertically by operating the winch and put
the pins (K) to the hinges once elevated. In
the event that the carriage does not have
mounted truss lying in the lifting direction
of the truss (T2, T3 & T4), a stable minimum
load of 90kg at the support (P) for lifting the
truss will be required.
8. Once the truss is raised with the pins places
on the hinges (K), engage the hook (J) on the
shackle of the carriage (Z) then raise the it
using the winch handle (M).
9. With the carriage lifted halfway up, put
the straps (R) and continue lifting up to
the desired height. After that, to ensure the
tower, you are advised to remove the handle
(M) from the winch.
10. To change or add points of connection to
the car, it is advised to remove the carriage
from the tower, unscrew the connectors with
an allen wrench size 8 and then screw again
in the corresponding position.
11. For the process of lowering and folding,
reverse the order of the steps.
ATTENTION:
WE RECOMMEND ASSEMBLING THE
PERIMETER TO THE FACES OF THE
CARRIAGE BEFORE RAISING THE
TOWER

5. MAINTENANCE

1. Periodically check cable status. If the cable
seems to have broken wires or crushing,
replace immediately with a new one. Never
use the ground support tower with cables
in bad conditions. Only use galvanized
steel under EN 12385-4. Cable maximum
load: 2.000kg. Cable torsion resistance:
1.770N/mm². Cable diameter: 6mm. Cable
composition: 6x19+1.
2. The ground support tower is supplied
fully greased from factory. Nevertheless, the
crown gear of the winch, to the threaded bar
of the stabiliser outriggers and the profiles,
because of its use periodical greasing is
recommended.
WARNING:
DO NOT GREASE OR LUBRICATE
BRAKING MECHANISM
Braking disks were greased with a special
heat and pressure resistant grease. No other
product must be used to prevent negative
influence on brake functioning.
3. Ground support tower TRC-700, must be
checked by an expert a minimum of once a
year as per its use.
4. Only original spare parts must be used to
ensure continued safe use. The user loses all
guarantee rights if spare parts other than the
originals are incorporated or the product is
modified in any way.
5. To request any spare part, contact the
manufacturer or an authorised distributor
within your territory.
ENGLISH
13 13