Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
4. HOW TO USE
1. Place the ground support tower over a firm
and flat surface on its working place.
2. In case it is not already, put the section(T1)
on the base (B) and introduce the chariot (C).
3. Remove the outriggers (A) from their
transport supports (D) and insert them
into their working positions checking that
the safety pin (K) is properly operated and
stabilize the tower with stabilizers (E) paying
attention to the bubble level (L).
4. Remove the support (P) position and
insert in its housing using its pin (F).
T1
B
I
J
T4
O
T3
V
J
12 12
5. Install the perimeter of truss to the faces of
the carriage (C) as should be available once
the structure is elevated, in case of a simple
truss porch, two TRC towers will be needed
at either end, for a squared or rectangular
perimeter four TRC towers will be needed,
one at each vertex.
6. Place the truss section (T2) attached to the
end of the first one (T1) where the hinges are
(G). Place the pins to the truss and continue
joining all the sections (T3 & T4), place the
piece (V) at the end of the last section (T4)
and remove the two rear hinge pins (K).
7. Unwrap the cable (H), pass through the
pulleys (O) and attach the hook (J) on the
P
A
G
I
K
Z
T2
H
D
C
S
L
F
P
E
P
R
M
Tabla de contenido
