Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND REPAIR
Troubleshooting
If the OPERATION / WATER LEVEL LED flashes and the buzzer
sounds an alarm, please turn off the device, add tap water and
restart the device.
If the OPERATION / WATER LEVEL LED flashes and the buzzer
sounds an alarm, check whether conventional tap water has been
used. Do not use rainwater, water from cistern or distilled water.
If the OPERATION / WATER LEVEL LED is still flashing and the
buzzer is alarming after filling with normal tap water and
restarting, immediately turn off the device and contact customer
service.
If the ON-OFF / HOT WATER LED + STEAM LED + OPERATION /
WATER LEVEL LED are all flashing, please turn off the unit and
wait 30 minutes. Then restart the device to check. If the 3 LEDs
are still flashing, please stop using it and contact customer service:
Water LED won't stop blinking and unit shuts down. Check if
the lever was pressed continuously during the heating process.
Otherwise the device switches off automatically after 2 minutes.
68
The device switches off. Check whether the cable used is
designed for the required 3500 W. If you use a cable drum, it must
be completely unwound. If the cable fuse blows, the cable is not
sufficiently secured. Use an appropriate cable.
No water comes out of the Unkrautfuchs. The Unkrautfuchs is
clogged or there is a narrowing in the device. Completely disassemble
the lance and only allow the water to flow through the gun. If the
water flows without a lance, carry out the following steps:
1. The water nozzle is clogged. Remove dirt or limescale from the
nozzle holes using the cleaning needle provided.
2. A seal is defective, has slipped or has been pressed too hard. Check
the seal between the lance and gun and replace if necessary.
WARNING!
If there is a lack of water, the OPERATION / WATER LEVEL LED
will start flashing with an alarm tone. In the event of an error,
all three LED lights will start flashing simultaneously with an
alarm tone.
SAFETY INSTRUCTIONS
EN
69
