Hilti SD 5000-A22 Manual De Uso página 20

Trouble or fault
The screwdriver
doesn't work.
The screwdriver
doesn't work and
one LED blinks.
The screwdriver
doesn't work and
all four LEDs blink.
Screw is not com-
pletely offset and
tool stops.
The control switch
can't be pressed, i.e.
the switch is locked.
The screwdriver runs
but the screw can't
be driven.
Running speed sud-
denly drops consid-
erably.
The battery runs
down more quickly
than usual.
The battery doesn't
engage with an audi-
ble click.
The screwdriver or
the battery gets very
hot.
14 English
Possible cause
The battery is not in the
working position.
Low battery.
The battery is too hot or
too cold.
The overload cut-out
has been activated.
Battery level too low.
The safety lock is en-
gaged.
The wrong direction of
rotation is set.
Low battery.
Battery condition is not
optimal.
The retaining lugs on the
battery are dirty.
Electrical fault.
Action to be taken
▶ Insert the battery.
→ page 10
▶ Insert a charged
battery.
▶ Charge the battery.
→ page 9
▶ Bring the battery to
the recommended op-
erating temperature.
▶ Release the control
switch and then press
it again. Reduce the
load on the tool.
▶ Insert a stronger Hilti
battery ≥ B22/3.0Ah.
▶ Set the forward / re-
verse selector switch
to forward or reverse
rotation.
▶ Use the forward
/ reverse selector
switch to set the right
direction of rotation.
▶ Charge the battery.
→ page 9
▶ Have the battery
condition diagnosed
by Hilti Service or fit a
new battery.
▶ Clean the retaining
lugs and engage the
battery in the working
position.
▶ Switch the screw-
driver off immediately,
remove the battery
and contact Hilti Ser-
vice.
2242466
*2242466*