Scheppach TIGER 2000S Traducción Del Manual De Funcionamiento Original página 27

10.7 Grinding with the blade fixture (Fig. 12)
The blade fixture is designed for blades with a cutting
edge of approx. 40 - 100 mm and for drawing blades.
• The edge angle is adjusted with the tool support and
the adjusting ring.
• The grinding support consists of a carrier, a clamp-
ing plate with a locking screw and a connecting
screw, as well as an adjusting ring (22).
• Clamp the blade:
• The clamping screw (21) must be released.
• Clamp the blade with the clamping screw (21).
• Then fasten it with the connecting screw (20).
• The blade is now firmly clamped in the rest.
• The edge angle at the blade tip depends on the dis-
tance to the handle and the tip at which the blade
is clamped.
• When the blade is correctly clamped, the edge an-
gle is the same over the entire cutting edge. Use the
edge angle from the previous sharpening operation
or use the setting gauge with the tool support to
roughly adjust the edge angle.
• Fine adjustment can take place using the adjusting
ring (22) on the device.
• Honing: Always sharpen with the direction of
rotation.
10.8 On/off switch (6) (Fig. 1)
• To switch on the machine, press the green "I" button.
• To switch the device off again, press the red button "0".
10.9 Friction wheel adjustment with the star grip
screw on the rear side (Fig. 13)
• You can adjust the contact pressure on the friction
wheel with the star grip screw (23) on the back of
the machine housing (see Figure 13). This may be
necessary if the leather honing wheel or grindstone
stops during sharpening or honing. Turn the star
screw clockwise to increase the tension. Tighten the
star grip screw only until you feel a slight resistance.
Do not over-tighten.
Important:
After working with the machine, the back of the
star grip screw (23) must always be loosened coun-
terclockwise so that the engine shaft no longer
presses against the friction wheel.
11. Cleaning and maintenance
m Warning!
Switch off the machine and pull out the mains plug be-
fore performing setting, maintenance or service work!
Cleaning
Keep all safety devices, ventilation slots and the en-
gine housing free from dirt and dust insofar as possible.
Wipe the device clean with a clean cloth or blow it off
with compressed air at low pressure.
We recommend cleaning the device immediately after
each use.
Maintenance
The device has no further internal parts that require
maintenance.
Optional accessories:
fixture for axes (fixture 40), art. no. 89490712
fixture for blades (fixture 60), art. no. 89490708
Service information
Please note that the following parts of this product are
subject to normal or natural wear and tear, and are
therefore also required as consumables.
Wearing parts *: Grindstone, grinding paste, leather
honing wheel, friction wheel
* May not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
12. Storage and transport
Store devices and accessories out of the reach of chil-
dren in a dark and dry place above freezing point. The
optimum storage temperature lies between 5 and 30
°C. Store the power tool in its original packaging. Store
the grindstone in a cool, dry and dark place.
m Attention!
It is essential that the device is secured against falling
or tipping over during transport.
The machine may only be lifted and transported by its
frame.
www.scheppach.com GB | 27