Idiomas disponibles
Idiomas disponibles
¢onve ing to LP Gas (ooot oued)
Converting
Surface Burners on
Models Equipped
with Sea ed Burners
(See Step 3 if range is equipped
with Dual Burners.)
Burner cap
Burner head
Screws
Burner base
Orifice spud
1. Remove
the grates, burner caps and burner heads.
2. Using
the torxdriver,
remove
the burner
bases
by
unscrewing
the 3 small screws
in each base. Lift
the burner
straight
out.
DO NOT
disconnect
the
wires
from
the
burner
bases unless the cooktop
needs to be raised.
3. Remove
the brass orifice spud under each burner
base by unscrewing
the spud from the fitting with a
7mm or a small adjustable
wrench
(depending
on
the size of your spuds).
Apply
a 314" wrench
to
the hex on the gas inlet tube as a back-up
when
removing
spud
to prevent
the
aluminum
tube
from twisting.
4. Install
orifice
spuds
according
to
one
of
the
following diagrams
(see []
or []),
for LP gas or nat-
ural gas, depending
on which you are converting
to.
[_
Orifice
Spuds
for Converting
to LP Gas:
LP orifice spuds are in a small plastic bag packed with
this Use and Care manual.
LP orifice spuds have a 2-
digit number
and the letter "L" on one side. Each ori-
fice spud will also have 1 or 2 grooves
on one side,
denoting
the location
on the range where
it is to be
installed
as shown below.
:
::::
::L::i_ !i:::;!i ¸
Orifice
Spuds
for Converting
to Natural
Natural
gas orifice
spuds
have
a 3-digit:
one side.
Each orifice
spud will also
have::1:;: 2 o_::3::::::::::
grooves
on one side with the letter
denoting
the location
on the range
Where
it is
installed
as shown
below.
5.
6.
Front of Range
To prevent
leakage,
make
sure
the orifice
spuds
are securely
screwed
into the gas inlet tubes.
Use a
small wrench to hold the inlet tube hex to prevent
it
from twisting.
Put old orifice
spuds
back
in the bag to save
for
possible
future conversion.
NOTE:
If an orifice spud is
_-_..
accidentally
dropped,
the
--_..'_%____
cooktop
can be raised
by
_
disengaging
the
2 front
clips with a large flat blade
screwdriver.
DO
NOT
attempt
to raise
the
cooktop
without
removing
all 4 burner bases.
If wires were disconnected
to remove
the cooktop,
feed wires through
the burner
holes
in the cooktop:
Attach
to each burner
electrode
terminal
carefullyi
making
sure not to bend the terminal.
Then
lower
cooktop
until it snaps over the clips.
Electrode
Tail Screw
--
Front of range
7. Carefully
insert burner bases straight
down with:the
tube
over
the orifice
spud.
Replace
the
screws,
making
sure the tall screw
is opposite
the burnL
er electrode
in each burner
base;
38
