Kärcher OC 3 Foldable Manual Del Usuario página 13

ATTENTION
Risk of damage due to frost!
An incompletely emptied device can be damaged by
frost.
Completely empty the device and accessories before
storing them.
Protect the device from frost.
Store the device in a frost-free place and not outdoors.
1. Finish operation, see chapter Ending operation.
2. Place the device in a closed room on a flat surface
and store it within the permitted ambient tempera-
ture, see chapter Technical data.
Care and service
DANGER
Touching live parts
Danger of injury from electric shock
Switch off the device and unplug the charger from the
device before performing any work on the device.
Cleaning the fine filter
Clean the fine filter regularly.
ATTENTION
Risk of damage due to improper cleaning!
The fine filter is damaged by improper cleaning.
Fault
The device does not run The charging state of the battery is too
Device does not reach
required pressure
Strong pressure fluctua-
tions or constant switch-
ing off/on of the device
The device is leaking
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Cause
low.
Motor overloaded; the motor circuit
breaker has tripped.
The ambient temperature is outside the
permissible range, see chapter Techni-
cal data, the motor circuit breaker has
tripped.
Not enough water in the water reservoir. 1. Make sure that there is enough clean, clear
The fine filter is dirty.
The nozzle is clogged.
The device leaks a small amount for
technical reasons.
Clean the fine filter only under running water against its
flow direction.
Do not use sharp or hard objects such as needles or
wire brushes.
1. Drain the water reservoir.
2. Pull out the fine filter.
Illustration I
3. Clean the fine filter with clean, clear running water.
4. Fit the fine filter into the device.
Troubleshooting guide
DANGER
Touching live parts
Danger of injury from electric shock
Switch off the device and unplug the charger from the
device before performing any work on the device.
Have repair work and work on electrical components
carried out by the authorised customer service only.
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Rectification
1. Charge the battery, see Chapter Battery
charging.
1. Switch off the device.
2. Switch the device on and resume opera-
tion.
1. Switch off the device.
2. Allow the device to cool down/heat up.
3. Switch the device on and resume opera-
tion.
Have the device checked by Kärcher Ser-
vice if this malfunction occurs repeatedly.
water in the water reservoir.
1. Clean the fine filter, see chapter Cleaning
the fine filter.
1. Clean the nozzle: Remove contamination
and debris from the nozzle hole, using a
needle and rinse with clean, clear water
from the front.
2. Make sure that there is enough clean, clear
water in the water reservoir.
1. In case of more serious leaks, have the de-
vice checked by KÄRCHER Service.
Technical data
Electrical connection/Battery
Nominal voltage of battery
Nominal power of device
Degree of protection
Protection class
Charger
Charger mains voltage
Output voltage
English
V 6
W 45
IPX4
III
V 100-240
V 5
13