Idiomas disponibles
Idiomas disponibles
Digital Multimeter/English
Function
Maximum Input
VAC
600V DC/AC
V DC or V AC
600V DC/AC, 200Vrms on 200mV range
mA DC
200mA 250V fast acting fuse
10A 250V fast acting fuse
A DC
(30 seconds max every 15 minutes)
Resistance,
250Vrms for 15sec max
Continuity
SAFETY SYMBOLS
This symbol adjacent to another symbol, terminal or
operating device indicates that the operator must refer to
an explanation in the Operating Instructions to avoid
personal injury or damage to the meter.
This WARNING symbol indicates a potentially hazardous
WARNING
situation, which if not avoided, could result in death or
serious injury.
This CAUTION symbol indicates a potentially hazardous
CAUTION
situation, which if not avoided, may result damage to the
product.
This symbol advises the user that the terminal(s) so marked
MAX
must not be connected to a circuit point at which the voltage
500V
with respect to earth ground exceeds (in this case) 500 VAC
or VDC.
2
Input Limits
This symbol adjacent to one or more terminals identifies
them as being associated with ranges that may, in normal
use, be subjected to particularly hazardous voltages. For
maximum safety, the meter and its test leads should not be
handled when these terminals are energized.
This symbol indicates that a device is protected throughout
by double insulation or reinforced insulation.
CONTROLS AND JACKS
1. LCD Display
2. Function switch
3. 10A jack
4. COM jack
5. Positive jack
6. Data Hold Button
7. Backlight Button
Note:
Tilt stand, fuse and battery compartment are on rear of unit.
SYMBOLS AND ANNUNCIATORS
•)))
Continuity
Diode test
µ
micro (amps)
m
milli ( volts, amps)
k
kilo (ohms)
Ω
ohms
VDC
volts direct current
VAC
volts alternating current
ADC
amps direct current
BAT
Battery test
Digital Multimeter/English
1
6
7
HOLD
OFF
600
600
V
AC
200
200
V
DC
2000
20
2000
20m
m
A
DC
2
200
200
m
m
2000
10A
k
200k
1.5V
20k
9V
BATT.
2000
200
CAT III 600V
10A
V
mA
COM
3
5
4
3
