Auxilab MEDIBAS+ Manual De Uso página 44

Rotor Time (min)
2
8.
Firstly turn the equipment on by pressing the On/Off switch placed at the back side of the
centrifuge; the LED display will light on.
9.
Rotor/adapter number setting: Press button
Turn the parameter setting knob until nº 2 is displayed.
10.
Time setting: Press button
corresponding LED indicator will light on → Turn the parameter setting knob until
number 20 is displayed. If you want to use seconds parameter, press again button
, the corresponding LED indicator will light on and then the parameter setting knob
can be rotated to set the seconds.
Once operation parameter has been set press the setting knob
vertically or wait until value on display flashes 3 times indicating that
the value has been saved.
11.
Acceleration and deceleration rates setting (values for both rates have a maximum value
of 9, increasing values reduce the time for reaching setting speed or cero speed
respectively). Press button
and the acceleration LED will light on → Turn the parameter setting knob until number 5 is
displayed → Press the knob vertically and digit on acceleration/deceleration display will
flash and deceleration LED will light on → Turn the parameter setting knob until number 3
is displayed → Wait for 3 seconds without pressing any button and the system will
automatically go out parameter setting mode and save parameters corresponding to
acceleration and deceleration rates.
12.
Speed setting: Press button
LED indicator will light on → Turn the parameter setting knob until number 4000 is
displayed.
Once operation parameter setting is finished, display will be below figure:
Speed rpm
20 4000
→ Digit on time display will flash and the
→ Digit on acceleration/deceleration display will flash
→ Digit on SPEED/RCF display will flash and RPM
- 43 -
ACC
2
→ Digit on rotor display will flash →
DEC
3