Idiomas disponibles
Idiomas disponibles
Note:
Make sure that the top of the reference
station is above the wall.
2.
Drill holes at the 2 marks in the wall for the 2
screws.
3.
Install the bracket on the wall with the 2 screws.
3.10.5.2 To install the bracket on a pole
1.
Attach the pole tightly to a wall, roof top or to the
ground. Make sure that the pole cannot move.
2.
Put the hose clamps through the slot on the rear
side of the bracket.
A
C
3.
Attach the bracket on the pole and tighten the hose
clamps with a flat screwdriver.
14 - Installation
B
3.10.5.3 To install the reference station
1.
Hold the reference station above the bracket and
align the arm of the reference station with the slots
in the bracket.
2.
Push the reference station down to attach it to the
bracket.
3.
Push and hold the cable cover and move it down
to remove it from the reference station.
4.
Connect the low-voltage cable to the reference
station. Put the low-voltage cable in the cable slot.
2211 - 002 - 30.11.2023
