Checking Chain Lubrication; Chain Brake - Stihl MS 441 C-MQ Manual De Instrucciones

English

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
34

Chain Brake

The chain brake system on your saw
has two functions:
Standard STIHL Quickstop chain
N
brake and
STIHL Quickstop Plus chain brake
N
system
The standard STIHL Quickstop chain
brake utilizes the front hand guard as the
activating mechanism and is designed to
stop the chain within fractions of a
second. The STIHL Quickstop Plus
chain brake system, on the other hand,
is designed to stop chain rotation within
a second of the operator fully releasing
the rear handle.
To reduce the risk of personal injury or
property damage during cutting,
observe the characteristics that make
this saw different from saws not
equipped with a rear-handle-activated
STIHL Quickstop Plus chain brake
system. Before operating the chain saw
for the first time, make sure you are
familiar with how the STIHL Quickstop
Plus chain brake system works.
STIHL Quickstop Plus chain brake
system
Activating
When you fully release the rear
N
handle, including the throttle trigger
and throttle trigger lockout.
Disengaging
Press down the throttle trigger
N
lockout. This releases the clutch
drum and allows the chain to rotate.
MS 441 C-MQ