Hazet-Werk 7901 E Instrucciones página 27

Use of the device
1. Select operating mode
2. Select setpoint value
3. Select unit
4. Place a torque screwdriver / torque wrench in or on the input drive and work in the
desired direction
5. Remove the torque screwdriver / torque wrench and set the display to zero
(if necessary) by pressing the RESET button
6. Place a torque screwdriver / torque wrench in or on the input drive and work in the
desired direction
USB port
The USB port provides the power supply for the torque tester. The supplied USB cable
can also be used to connect the unit to a PC / laptop for transferring measured torque
values.
Connect the torque tester to the PC / laptop and a virtual com port appears in the
device manager. This com port should be selected and configured to match the program
used to display the measured torque values.
Measured torque values are sent to the PC / laptop when the RESET button is pressed
in any mode and a peak value is reset (either manually via the RESET button in dial or
click mode or when the automatic reset is triggered in click mode).
NOTE: system requirement:
Windows 10 (ff.) operating system is required to connect the torque tester to a
PC / laptop and the HAZET torque testing software.
Operating instructions
2
27